Service manual

How to set the Temperature:

Example: 80 Degrees = F 80 or 200 Degrees = F200 etc.

The two buttons on the right of the display set the temperature. If the temperature is

flashing then the heater control is in tuning mode. There is an alarm on the heater that

when the actual temperature falls outside a given range then it sends a fault to the control

panel that stops the machine. Wait for the temperature to come back up and reset the

fault and restart the machine.

The green digital display indicates the target temperature. The red digital display

indicates the actual temperature. It takes about 20-30 minutes for the heater to reach the

preset temperature. CAUTION: It takes about 2 hours for the heater to cool off after the

machine has been shut down. The faster the machine is running the higher the

temperature that you want for consistently good seals.

Touch Screen Menus:

There are four main menus on the touch

screen.