Service manual

Our obligation under the foregoing is limited to replace free of charge, including the lowest transpor-

tation cost, but not including installation or any other charges, any part that our inspection shows to be

defective provided that the part was properly installed, suitably maintained and not subject to misuse

or abuse, and further provided that the defective parts are returned to our plant within one (1) year

after delivery by us. Written permission for such return must first be obtained from CAMCO. A com-

plete explanation is required of the alleged defects and circumstances.

See the "How to Return for Repair" section of this manual.

WARNINGS AND CAUTIONS

Statements in this manual proceeded by the words warning or caution and printed in

italics

are very

important. We recommend you take special notice of these during service or repair.

WARNING

Means there is the possibility of personal injury to yourself or others.

CAUTION

Means there is the possibility of damage to the CAMCO unit.

INTERPRETATION OF INDEX DRIVE MODEL NUMBERS

In an effort to better understand the type of Index Drive you have purchased, the complete model

number as it appears on the name tag can be divided into five (5) main components.

EXAMPLE: 250P4H20-270

250 P 4 H20- 270

(1) (2) (3) (4) (5)

1. The basic CAMCO model series, usually the diameter of the cam follower circle

(i.e. 250 means

2.5" diameter).

2. The type of cam and output configuration

P = Parallel cam unit

RA = Right angle cam unit

RAD = Right angle cam / dial mounting output

RD = Roller gear cam / dial mounting output

RG = Roller gear cam unit

RDM = Roller gear cam / dial mounting output / motorized

E = Heavy duty right angle cam units / dial mounting

3. The number of stops.

Four (4) stops means the output shaft will make four starts and stops during one complete

360 degree revolution. The angle of each segment of output rotation is derived by dividing

360 by the number of stops.

EXAMPLE: 4 stops = 90 degree segments

(4 total)

4. Cam follower size.

The follower size is listed in 32nds of an inch.

Example: 1: H20 = 20/32nds = .625 inch diameter followers

Example: 2: H96 = 96/32nds = 3.00 inch diameter followers