Service manual

ON NON-WARRANTY
Replacement or spare parts, with approved credit, are sent F.O.B.our plant Wheeling, Illinois.
16
TO ORDER PARTS contact CAMCO "ORDER ENTRY DEPARTMENT" Wheeling, Illinois
Phone [phone] or Fax [phone].
A. Describe the part required and the 14 digit part number as listed in the Standard Bill of Materials
or a Special Bill of Materials pertaining to your specific unit (state which bill is being used,
Standard or Special bill).
B. Give as much of the above required information as possible.
ON WARRANTY
CAMCO will send replacement part freight prepaid via the most practical means. CAMCO will issue a
"Returned Material Authorization Number" (RMA#) for the return defective parts for inspection. CAMCO
will bill the customer for repair parts. When inspection of the returned parts has been completed and
determined to be a warranty problem CAMCO will issue credit to the customer for the repair parts and
freight charges.
Type 2 motions require double-lobe trip cams since one revolution of the input will produce 2 dwells.
Type 2 units are typically used when a higher number of stops are required.Please remember that
CAMCO cannot preset the trip cam. Every customer has different requirements which make standard-
ization very difficult.
Another potential problem is double indexing. This can happen if limit switch does not close the contacts
for a sufficient peroid necessary to energize the holding relay. Higher speed operation or an improperly
adjusted limit switch may cause this problem.
95