Manual

2.5 - Wiring in the Tuned Antenna
2.6 - Coding the Remote Controls
1. REMOVE THE BATTERY COVER & CASING OF THE REMOTE CONTROL HANDSET TO
REVEAL THE DIAGRAM BELOW
Bat
Battery 12V
ON 1 2 3 4 5 6 7 8 9 10
7 8 9 10
ON OFF
Bt
Batt
1
ANTENNA WIRING
POINT
2. SET THE BANK OF
DIPSWITCHES ON
ALL REMOTES TO
EXACTLY THE SAME
CODE OF YOUR
CHOICE.
3. UNLESS PROGRAMMING FOR
GATES AND GARAGE DOORS TO
OPEN BY REMOTE CONTROL FROM
THE SAME HANDSET ENSURE
THAT THE JUMPER STRAPS SHOWN
HERE ARE IN THE SAME POSITIONS
ON ALL REMOTES.
2.7 - Powering up the Control Panel
CONNECT PROTECTED MAINS POWER TO TERMINALS L1 + L2 IN THE CONTROL PANEL (L2
BEING LIVE!). ENSURE THAT THE CONTROL PANEL IS ADEQUATELY EARTHED.
11