Manual

3.5 - Programming the Remote Controls
to the Control Panel
To use the remote control system, proceed as follows:
A) Turn power OFF and insert AF radio frequency board then turn power back on
B) Code the transmitter. See the relevant instruction sheet
(See Fig 11)
C) To store the code on the circuit board Proceed as follows:
Press and hold down the programming button on the radio receiver card (the signal
LED will start to flash)
At the same time transmit on the top button of your remote control; keep both the top
button and the yellow receiver button pressed until the LED stops flashing and remains
on constant. It will then go out to indicate that the code has been successfully
stored.
N.B. If you wish to change the code on your transmitter in the future,
simply repeat the procedure above with all the remotes on the
installation.
WARNING: Disconnect the power supply from the control board before inserting
OR removing the AF radio-frquency card from the socket.
17