Manual

5.4 - Motor Torque Settings
Description of Control Panel:
Micro-processor controlled electrical cabinet powered by 230V (a/c) at
50-60Hz, single phase. Designed for control of CAME (ATI/FERNI/FROG), for hinged
gates, hinged industrial doors. Designed and built entirely by CAME to meet
UNI8612 safety standards at an IP 54 level of protection. Housing made of ABS is
equipped with vents to provide internal air circulation. Guaranteed for 3 years, unless
tampered with. This control panel is powered 230V a.c across terminals L1 and L2,
and is
protected by a 5A fuse on the main power line. Control systems are powered by low
voltage and protected by a 2A fuse. The accessories total wattage (24V) must not
exceed 20W.
Safety:
SAFETY BEAMS CAN BE CONNECTED TO OBTAIN:
Re-Opening: During closing (2-C1), if the beam is broken while the gate is
closing, they will reverse the direction of movement until the gate is
completely open and will stay open until the obstacle is removed.
Total Stop: (1-2) Creates immediate stop of gate movement without automatic
closing: (a pushbutton or radio remote control must be
actuated to resume movement).
N.B IF A NORMALLY CLOSED SAFETY CIRCUIT
(2-C1, 1-2) IS OPENED, THE L.E.D WILL
FLASH TO INDICATE THE FACT THAT THE BEAM IS
BROKEN.
Accessories that can be Connected to this Unit:
“Gate in Motion” Lamp:
The lamp that lights the manoeuvering zone:
it remains lit from the the moment the gate begins to open until they are completely
closed (including the time required for the automatic closure).
When automatic closure is not enabled, the lamp remains lit only during movement
(E-E3).
23