Use and Care Manual

Models CE7002, CE7003, CE7004

www.CH-Commercial.com

Unpacking

Do not lift or move unit without appropriately rated equipment. Be sure

the unit is securely attached to lifting device used. Do not lift unit by

holding onto tubes or coolers. Do not use unit to lift other attached equipment.

Afterunpackingtheunit,inspectcarefullyforanydamagethatmayhaveoccurred

during transit� Check for loose, missing or damaged parts� Check to be sure all supplied

accessories are enclosed with the unit� In case of questions, damaged or missing parts,

pleasecall1-888-606-5587forcustomerassistance.

Do not operate unit if damaged during shipping, handling or use.

Damage may result in bursting and cause injury or property damage.

REQUIRED ITEMS - NOT INCLUDED

◆ Oil

◆ VibrationIsolatorPads

Disconnect the battery cable on models with electric start

and release all pressure from the system before attempting to

install, service, relocate or perform any maintenance.

Do not lift or move unit without appropriately rated

equipment. Be sure the unit is securely attached to lifting

device used. Do not lift unit by holding onto tubes or coolers. Do not use unit to lift other

attached equipment.

Never use the wood shipping skids for mounting the compressor.

PICKING THE LOCATION

Do not locate the compressor air inlet near steam, paint spray, sandblast

areas or any other source of contamination.

The compressor should be installed on a foundation of sufficient strength and rigidity

to support it without vibrating� It is recommended to use shims under the mounting

feet to level the compressor, to prevent “rocking” and excessive vibration� To reduce

vibration, isolator pads are recommended� When isolators are used, install a flexible

coupling between the tank and any pipe permanently attached to the tank�

When permanently installing compressor for stationary use or mobile

use such as on a truck, avoid overstressing a mounting foot by “pulling

the foot down” to the ﬂoor. This may cause eventual failure.

Installation

Figure 2 - Isolator pad