Use and Care Manual

Models CE7002, CE7003, CE7004
Installation (Continued)
www.CH-Commercial.com
7
LUBRICATION
THIS UNIT CONTAINS NO OIL. Before operating
compressor, fill to the center of the sight gauge
(see Figure 6).
Using any other type of oil may shorten pump
life and damage valves.
Recommended Oil (2 Options)
• SingleviscositySAE30ISO100non-detergentcompressor
oil.AvailablefromCampbellHausfeld,partnumber
ST126701AV.
• 10W30syntheticoilsuchasMobil1
®
�
Oil Capacity
CE7000Series� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �2 quarts
Fillthepumpwithoiltothecenterofthesightgaugeusingoil
fillopening(seeFigure6).Do NOT fill the pump through the
breather cap opening as this may cause oil to leak and spray
out during operation.
NOTE: Some residual oil may still be in the pump from factory
testing leaving a thin coat on the sight gauge; however, there is
not enough oil to operate the unit�
Figure 6
Oil Drain Plug
Oil Fill Plug
SIGHT GAUGE
Full
Low