Manual

Appendix F. Extended ASCII Command Set
Loading data into the random transmission buffer, triggers the random
reporting sequence. Once triggered, the random reporting mechanism will
send the data loaded in the buffer for the number of transmissions as specified
by the random repeat count. The buffer will be cleared automatically when the
number of transmissions specified have occurred.
If the command is received within 1 minute or during a random transmission,
the data will not be included in the current transmission but will be buffered for
the next one.
If there is more data loaded into the buffer than can be transmitted at the
assigned bit rate the message will be truncated.
F.4.6 Read Length of the Message in the Random
Transmission Buffer
Syntax:
RML
Access level: USER
TX320 State: Enabled/Disabled
Returns the number of bytes stored in the random transmission buffer.
F.4.7 Read the Maximum Random Message Length
Syntax:
MRML
Access level: USER
TX320 State: Enabled
Returns the maximum number of bytes that can be transmitted at the current
random transmission bit rate.
F.4.8 Clear Random Transmission Buffer
Syntax:
CRB
Access level: USER
TX320 State: Enabled/Disabled
Clear the random transmission buffer.
F.5 Status and Other Commands
The following commands are used by the host to determine the status of the
transmitter for display and diagnostics purposes. These commands can be
entered with transmissions enabled or disabled.
F-12