User Manual

1
1
.
.
ATTACH THE FAN BLADES
- Attach the blades to the fan motor assembly using the screws and flat
washers.
Pg. #4
Pg. #9
- Push all connected wires up into ceiling box.
- Position the receiver into the canopy as shown direction.
C
Fig. 7
Reciever
Mounting
Plate
Canopy
Hook
5.
6.
ELECTRICAL HOOK-UP
4
4
.
.
MOUNTING FAN ASSEMBLY
ENGAGE HEMISPHERE (Downrod Mount Only)
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
Downrod
Hemisphere
Groove
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
a 8 .giF
b 8 .giF
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
(A)
(B)
(B)
Washers
(A)
- Place two screws and washers on mounting plate (marked B on diagram)
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on
diagram) then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram)
then tighten the two screws (marked B on diagram).
Fig.2a
Fibre Washer
Metal Washer
Blade
Bracket Screw
Blade
Blade Bracket
Fig.2b
Screw
Light Kit
b2 dna a2.giF :erbilaC ledo m roF
- Mount the motor cover to the fan motor assembly, aligning screws in
motor fan assembly with the key slots on the motor cover. Turn cover
to lock in place and tighten screws.
star
washer