Programming instructions

12
3. Make the changes.
 Beside Name, type a descriptive name (maximum 15 characters) for the device.
 Beside Address, type the address of the device, exactly as it appears on the product. For
information about where to find the address, see the Power Block installation guide.
 Beside Type, select the model of the Power Block.
 Beside Building, select the building in which the device is located.
 If you have a PBx Power Block that is connected to a Phason Wireless Adapter (PWA),
beside Wireless adapter, select the address of the PWA.
4. Click OK to save the device information and return to the Configuration window.
To remove a Power Block
1. In the main window, click Configuration, and then Ventilation.
2. Below Your Power Blocks, select the Power Block you want to remove and then click Remove
Power Block.
A warning message displays.
3. To remove the Power Block, click Yes. To cancel and return to the previous window, click No.
Logging in new Power Blocks
When you add, replace, or change the address of a PB-1 to PB-6 Power Block, you need to login
that Power Block before Select Ventilation can use it. You do not need to login PBx Power Blocks;
they login automatically.
To activate or deactivate a Power Block
1. In the main window, click Configuration, and then Ventilation.
2. Below Your Power Blocks, select the Power Block you want to activate or deactivate.
3. Below Active, click and drag the slider to the status you want.