Programming instructions

Configuring Power Blocks
21
3. Click Edit relay 4 for actuator 1, or Edit relay 6 for actuator 2.
The Relay configuration window displays.
4. Select Actuator 1.
5. Beside Name, type a descriptive name for the actuator.
6. If you are using tunnel mode, select Closed during tunnel mode.
7. If the actuator needs to close when it is raining, select Closed when raining. This option is available
only if you have a Phason Rain Sensor connected.
8. Click OK to save the changes and return to the Power Block configuration window.
9. If required, repeat steps 3 to 8 for actuator 2.
10. Follow the instructions for configuring other relays or variable stages, or click Close to return to
the Configuration window
 Enabling additional probes, deicing, and rain detection (on page 16)
 Configuring variable stages (on page 18)
 Configuring relays for curtain control (on page 22)
 Configuring relays for heating, cooling, and duty cycle (on page 24)
 Configuring relays for timed events (on page 26)
 Configuring relays for disconnecting DC variable stages (on page 28)