Programming instructions

38
 Use smoothing to "draw" a straight line between two points.
 Click Smooth line.
 Click the first point; in other words, the starting point you want to adjust.
 Click the second point, the last point you want to adjust.
 Select Ventilation adjusts all the points between the two selected.
 The Power Block must be in normal operation mode to program ventilation
curves. For more information, read Using normal and empty room modes on page
31.
 If the master set point curve is enabled, you cannot manually adjust the master
set point for that Power Block.
 If a minimum ventilation curve is enabled, you cannot manually adjust the idle
speed for that variable stage.
 Use the Master settings worksheet on page 82 when programming Power Block
settings.
To clone curves
1. In the main window, click Settings, and then Ventilation.
2. Below Your Power Blocks, select the Power Block you want to program and then click Edit curves.
The Ventilation growth curves window displays.
3. Click Clone growth curves.
The Growth curve cloning window displays.
4. Select the Power Block with the growth curves you want to copy.
5. Click OK to copy the curves and return to the Ventilation growth curves window.
You cannot undo or cancel a growth curve clone.
First point
Second point
First point
Second point