Programming instructions
Programming equipment settings
55
A This button displays the curtain settings.
B This is where you select the curtain you want program.
C These are the set point and idle band settings for the selected curtain.
To adjust a setting, click and drag its slider up or down.
To adjust a setting by 0.1-degree or 1 percent increments, click the slider and then press UP
or DOWN on your keyboard.
To adjust a setting by 1.0-degree or 10 percent increments, click the slider and then press
PGUP or PGDOWN.
D These are the opening and closing run and idle durations.
To adjust a duration, click and drag the number up or down.
To adjust a duration by 1 minute or 1 second increments, click the number and then press
UP or DOWN on your keyboard.
To adjust a duration by 10 minutes or 10 second increments, click the number and then
press PGUP or PGDOWN.
After the room is properly set up and balanced, you should not need to change
the curtain settings. Changing the settings after the room is set up can affect the
ventilation balance in the room. If you need to change settings after the room is
set up, you should change the Power Block settings. For more information, read
Programming Power Block settings on page 31.
If the Power Block is in empty room mode, curtain settings are not available and
curtains are closed.
Use the Curtain worksheet on page 87 when programming curtains.
To program curtains
1. In the main window, click Settings, and then Ventilation.
2. Below Your Power Blocks, select the Power Block you want to program and then click Edit
settings.
The Ventilation settings window displays.
3. Below Equipment settings, click Curtains.
The window displays the curtain settings.
4. If the curtain you want to program is not selected, beside Curtain, select the one you want.