Programming instructions

82
Master settings worksheet
 Enter your Power Block settings in the table below.
 Use the information in the table to program your master settings in Select Ventilation.
Configuration and information
Name Address
Building Type
Master set point
Master set point This is the target temperature.
Growth curves
Enabled? Set point
Master set point curve Yes No
There are too many details to show curve settings here.
VAR 1 min ventilation Yes No
VAR 2 min ventilation Yes No
VAR 3 min ventilation Yes No
VAR 4 min ventilation Yes No
Alarm settings
Low temperature 
The lowest temperature to which you can safely allow the zone to
fall; cannot be higher than high alarm temperature
High temperature 
The highest temperature to which you can safely allow the zone to
rise; cannot be lower than low alarm temperature
Bias offset 
The number of degrees to add to the high alarm temperature when
the outdoor temperature is higher than the alarm temperature.
High alarm maximum 
The highest temperature to which you can safely allow the zone to
rise; cannot be lower than high alarm temperature
Temperature setback
Enabled? Start time Stop time Setback
DIF Yes No : :
Power save Yes No : :
 Temperature in °F/°C, range: 14.0 to 122.0°F, –10.0 to 50.0°C
 Temperature in °F/°C, range: 0.0 to 25.0°F, 0.0 to 14.0°C
 Temperature in °F/°C, range: 0.0 to 20.0°F, 0.0 to 11.1°C