Operation Manual

Scanning a Document

Other Scan Operations

Another way of scanning originals is “verify scan.” With “verify scan,” you set the

number of originals before you start scanning, and the DR-5060 verifies the

number you set against the number of scanned pages. If the number of scanned

pages differs from the preset number, an error is displayed.

Verify Scan

Verify scans are performed in the scanner’s Count Only mode. The verify scan

function verifies the number of actually scanned pages in the original against a

pre-counted (entered) number of pages. The verify error occurs if the number of

scanned pages differs from the pre-counted number. (See “Verify Errors” P. 46)

Press the Count Only key on the operation panel.

The Count Only key lights, and the scanner enters the Count Only mode.

Feeding Option [Semi-Auto] lights.

Place the original on the document tray, and press the Start key.

The original is fed, and the number of counted pages is displayed on the

counter.

MEMO

● You can set the count start value before you press the Start key by pressing

the

or key.

● If you already know the number of pages in the original, you can set the

counter by pressing the

or key without pressing the Start key.

When the number of original pages has finished being counted,

press the Count Only key to cancel the Count Only mode.

Open the Feeder Options panel, and mark the [Verify Enable]

check box. (See “Feeder Option” P. 63)

Set the feeder option to any mode other than [Manual], and

perform [Scan Batch to File].

The verify error occurs if the number of actually scanned pages differs from the

number set in the Count Only mode. If the numbers match, scanning is

discontinued.

Downloaded from www.Manualslib.com manuals search engine