EOS Utility for Windows Instruction Manual (for EOS DIGITAL cameras released in 2006 or earlier)
5151
1
2
3
4
Introduction
Contents at
a Glance
Downloading
Images
Camera
Settings
Remote
Shooting
Reference
Preferences
Index
O If there is insufficient charge left in the camera battery, the camera
cannot communicate with EU. Either replace with a fully charged
battery or use the DC coupler kit provided with the 1D series,
or an AC adaptor kit (sold separately) for other
camera models. Your computer does not supply power to the camera
through the interface cable.
O For camera models other than the , turn off
the LCD monitor. You cannot communicate with the camera when you
are displaying images through the camera’s LCD monitor. Always
connect the camera and your computer after turning off the display in
the LCD monitor.
D60
D30
30D
REBELXTi
400D
O Operation of the Auto power off function will automatically switch the
camera off, disabling communication with EU, if you turn the Auto
power off function to [ON]. Remove the checkmark from [Auto power
off] in the [Basic settings] tab sheet of the preferences or set the Auto
power off function in the camera to [OFF].
O If you do not perform any operation while the camera and computer
are connected, depending on the computer system, a confirmation
message may appear on the screen asking whether you wish to
continue communicating with the camera. If you do not perform any
operation after this message appears, communication with the
camera is terminated. To re-establish communication, press the
shutter button down halfway or set the camera’s power switch to
< OFF > and then back to < ON >.
O Do not put your computer to sleep while it is connected to the camera.
If your computer goes into sleep mode, never disconnect the interface
cable while your computer is still in sleep mode. Always wake your
computer up while it is still connected to the camera. Depending on
the type of computer, disconnecting the interface cable while your
computer is in sleep mode could prevent the computer from waking
up correctly. Refer to the computer User’s Manual for more
information on sleep mode.
O In Digital Photo Professional, select the [Tools] menu [Sync folder
with EOS Utility].
Communication between EU and the camera disconnected
Remotely shot images using EU do not display in DPP
COPY