Specifications

1-12
Before Using the Machine
NOTE
– If there is less time than specified in <AUTO SLEEP TIME> remaining before sending a job which has
been reserved for delayed sending, the machine will not enter the Sleep mode completely.
– If you are using a management application (such as NetSpot Console) to view or manage the settings
and status of the machine via the network, the machine may not enter the Sleep mode completely.
– If you are using the machine as a Windows printer, the machine may not enter the Sleep mode
completely if SNMP Status is enabled for your operating system (unless your computer is turned OFF).
For more information on disabling SNMP Status, contact your network administrator.
– In some cases, the energy consumption level in the Sleep mode is <HIGH> even when the energy
consumption level is set to <LOW>, such as when:
• A job is being processed (including a forwarding job, report job, receive job, and sending a forwarding
done notice).
• Any of the following settings are set in the Additional Functions menu:
*
If there is more time than specified in <AUTO SLEEP TIME> remaining before the set time limit is
reached, the machine consumes the same amount of energy as when the energy consumption level is
set to <LOW>.
– The default setting is <LOW>.
– For information on each setting, see Chapter 1, “Advanced Send Features” or Chapter 3, “Network” in
the Advanced Operation Guide.
SYSTEM SETTINGS
COMMUNICATION MEMORY LOCK MEMORY RX TM is set to
ON*.
NETWORK SETTINGS TCP/IP SETTINGS
SMB SETTINGS
E-MAIL/I-FAX
DHCP is set to ON.
USE SMB CLIENT is set
to ON.
POP INTERVAL is set to
more than 1MIN.