Owner manual

Control Panel
T urning the Printer On and Off
T urning the printer on
1. Press the Power button to turn on the printer .
After all lamps are lit and then go of f, the printer starts up.
Initializing is displayed on the top line of the Display Screen , followed by the printer model
and version number .
Initializing
2. The printer goes online after startup, and the Online lamp and paper source section lamp
remain lit.
The printer will not go online in the following situations. T ake the appropriate action.
• The T op Cover is open
Close the T op Cover .
• The Ink T ank Cover is open
Close the Ink T ank Cover .
• The Printhead is not installed
Please see “Replacing the Printhead”. (→P .61 1)
• Ink T ank is not installed
Please see “Replacing Ink T anks”. (→P .600)
• If “ERROR” is shown on the Display Screen .
T urn of f the printer and contact your Canon dealer .
• The Online lamp and Message lamp are not lit (even once), and nothing appears on the Display
Screen
Make sure the printer is plugged in correctly . Check the connection at the plug and electrical outlet.
Important
• Starting the printer when it is connected via the USB cable to a Macintosh computer that is of f may
cause the computer to start up at the same time. T o prevent this, disconnect the USB cable before
starting the printer . Connecting the printer to the computer via a USB hub may solve this issue.
Printer Parts 25