Owner manual
Messages regarding printheads
Messages regarding printheads
Online Key / and recalibrate
Band Adj Error / Please Readjust
Cause Corrective Action
The feed amount cannot be adjusted; highly
transparent lm is loaded.
Adjust the feed amount manually .
( → P .590)
Printhd Adj Err / Please Readjust
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
( → P .608)
2. Clean the Printhead if the nozzles are clogged.
( → P .610)
The Printhead cannot be aligned; highly transparent
lm is loaded.
W e recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
( → P .581)
Printhead / Check Nozzles
Cause Corrective Action
If printing is faint, clean the Printhead.
( → P .610)
The printhead nozzles may be clogged.
Press the Online button to continue with printing.
However , note that this error may af fect the printing
quality .
T o cancel printing, press the Stop/Eject button.
Check Printout
Cause Corrective Action
The Printhead nozzles are becoming clogged. If printing is faint, clean the Printhead .
( → P .610)
Printhead / Please Replace
Cause Corrective Action
An incompatible Printhead has been installed. Install a Printhead specied for use with the printer .
( → P .61 1)
Open the T op Cover . If the Carriage is visible, replace
the Printhead with a new one.
( → P .61 1)
There is a problem with the Printhead .
If, after opening the T op Cover , you see that the
Carriage is not visible, follow these steps.
1. Close the T op Cover and press the Online button.
2. Replace the Printhead .
( → P .61 1)
694 Error Message