Owner manual

Other Messages
Power On / Again
Cause Corrective Action
Fastening tape or the Belt Stopper has not been
removed inside the T op Cover .
Follow the steps below , referring to the Quick Start
Guide as needed.
1. T urn the printer of f.
2. Open the T op Cover and remove the tape or Belt
Stopper .
3. T urn the printer on.
There is a paper jam. Follow these steps.
1. T urn the printer of f.
2. Remove the jammed paper .
( → P .169)
( → P .122)
( → P .174)
3. T urn the printer on.
4. Reload the paper .
( → P .87)
( → P .82)
( → P .89)
T urn of f the printer and wait for three seconds or
more before restoring the power .
There is a problem with the printer .
If the message is still displayed after this, write down
the error code and message, turn of f the printer , and
contact the Canon dealer for assistance.
Power On / Again / Multi-sensor Err
Cause Corrective Action
Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction.
T ake steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Cannot update rmware
Cause Corrective Action
Check the rmware version.
( → P .637)
Y ou have uploaded rmware for a dif ferent model.
If the message is displayed again, contact your
Canon dealer for assistance.
698 Error Message