Setup Guide

2
Preparations
Remove the orange tape used to secure
the roll holder to the printer.
4
Three people should hold the printer's carrying handles and place the printer on a table or
other fl at location.
When moving the printer, fi rmly grasp the
carrying handles. Holding the printer at
other positions is dangerous, and may
cause injury and damage if the printer is
dropped.
•
3
The iPF780 Series/iPF785 Series weighs
approximately 56 kg and the iPF680
Series/iPF685 Series approximately 46 kg
by themselves. Moving the printer requires
at least three people. Be careful to avoid
back strain and other injuries.
•
Caution
Plug the power cord into the power supply
connector on the right of the printer and
plug the other end into the outlet.
Move the printer to the location where you
will use it.
65
When moving the stand, lift the support rod
to the position (a) before closing the output
stacker and unlocking the 4 casters. Failure
to do so may lead to scratched fl ooring,
damage to the basket cloth, and injury.
• After you have moved the stand, be sure to
lock the 4 casters.
•
Caution
ON
OFF
a
Prepare the printer for use by installing the printer and connecting the power cord.
Remove the packing materials from the
top of the printer.
2
Install the printer. You can use the
following two methods for installing the
printer.
• Install with a stand
Assemble the stand and install the
printer referring to the Printer Stand
Setup Guide included with the stand.
After installation, proceed to step 4.
• Install without a stand on a table
Proceed to step 2.
1
Stands may be standard or optional
depending upon your model and location.
iPF780 Series/iPF785 Series: Standard
iPF680 Series/iPF685 Series: Optional
(equipped as standard in some locations)
•
MEM
O