Service manual

(8/25)
3. ERROR DISPLAY
Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (Alarm LED Blinking in Orange)
LED display
Alarm
LED
blinking
(Service
mode)
Error
(Error code)
Corrective action Remarks
There is no paper. 2 times No paper
(ASF)[1000]
Set paper in ASF, and press
the OK button.
The paper is jammed. 3 times Paper jam[1300] Remove the jammed paper,
and press the OK button.
Ink has run out.
Replace the ink
cartridge and close the
cover.
U041
- No ink[1600] Replace the ink cartridge(s),
or press the OK button.
When selecting to
press the OK
button, ink may run
out during printing.
The following ink
cartridge cannot be
recognized.
U051 / U059
5 times The ink cartridges
are not
installed[1401],
or a non-supported
ink cartridge is
installed[1485].
Check if supported ink tank(s)
is installed, and re-install
them properly, and then close
the front cover.
Some ink cartridges
are not installed in
place.
U075 / U076
7 times Ink cartridge’s
position is wrong.
[1487 / 1486]
Install the ink cartridge(s) in
the correct position.
The following ink
cartridge cannot be
recognized.
U052
15 times Ink cartridge is not
installed.[1682]
Re-install the ink cartridge(s)
properly and close the front
cover.
Or, turn off/on the printer
with the ink cartridges
installed.
The following ink
cartridge cannot be
recognized.
U053
4 times Ink cartridge is not
installed properly.
Re-install the ink cartridge(s)
properly and close the front
cover.
The waste ink
absorber is almost full.
- Waste ink absorber
full[1700],
or platen waste ink
absorber full[1710].
Pressing the OK button will
clean the error, and enable to
print.
<Replace Ink absorber kit
(QY5-0148-000)>
<Replace Platen waste ink
absorber QC1-6014-000)>
Waste ink absorber
full warning
(service call error)
may appear.
Incompatible device
detected.
- The connected
digital camera /
video camera is not
supported for
Camera Direct
Printing.
Disconnect the cable from a
the digital camera/video
camera, and press the Reset
button, and then re-connect
the cable.
The following ink may
have run out.
U161
An ink cartridge that
was once empty is
installed.
U162
- Ink remaining is
unknown.
[1685/1686]
Install an new ink cartridge, or
press the OK button.
* When an cartridge that was
once used (excluding the
cartridge used just before) is
installed, this error occurs.
(See 8-2. Major Functions (4)
Remaining ink level detection
function.)
When the error is
resolved by
pressing the OK
button, the function
for detecting the
remaining ink level
will be released.