Setup guide

Making Prints Using the Stack Bypass
1-53
1-531-53
1-53
1
11
1
Before You Start Using This Machine
If the following screen is displayed, adjust the width of the slide guide and set the size.
If the following screen is displayed, adjust the width of the slide guides to the size stored in the Stack
Bypass Standard Settings, or set the Stack Bypass Standard Settings to “Off.”
IMPORTANT
•
••
•
Set the paper size to the same size as the paper loaded in the stack bypass.
•
••
•
If Standard Paper for Stack Bypass is set to “On,” you can load only the registered paper types in the
stack bypass.
•
••
•
Designate which envelope type you want to set. If the envelope type is not designated correctly, a
paper jam will occur.
5
55
5
Select the type of paper (Plain, Heavy, etc.), and press “OK.”
Select the type of paper (Plain, Heavy, etc.), and press “OK.”Select the type of paper (Plain, Heavy, etc.), and press “OK.”
Select the type of paper (Plain, Heavy, etc.), and press “OK.”
IMPORTANT
•
••
•
Select the correct paper type to avoid a paper jam.