Instruction manual

Step

Connect the A-type (ﬂat) end of the USB cable to the USB

port on the computer.

Turn the computer on and start up Windows.

IMPORTANT

If a Wizard or dialog box appears by the Plug and Play automatic setup,

click [Cancel], and then install the CAPT software using this procedure.

Insert the supplied "LBP3500 User Software" CD-ROM into

the CD-ROM drive.

If the CD-ROM is already in the drive, eject the disk and re-insert it into the drive.

IMPORTANT

• If you are using Windows Vista and the [AutoPlay] dialog box appears,

click [Run AUTORUN.EXE].

• If CD-ROM Setup does not appear, display it using the following

procedures. (The CD-ROM drive name is indicated as "D:" in this manual.

The CD-ROM drive name may differ depending on the computer you are

using.)

- If you are using an operating system other than Windows Vista, select

[Run] from the [Start] menu, enter "D:\English\MInst.exe", and then click

[OK].

- If you are using Windows Vista, enter "D:\English\MInst.exe" in [Start

Search] under the [Start] menu, and then press the [ENTER] key on your

keyboard.

NOTE

If you are using Windows Vista and the [User Account Control] dialog box

appears, click [Allow].

Click [Easy Installation] or [Custom Installation].

[Easy Installation] allows you to install the printer driver and the instruction

manuals simultaneously. If you do not install the manuals, select [Custom

Installation].

Click [Install].