Instruction manual

52
Step
6
3 Remove the screw and remove the protective plate for the
expansion slot.
IMPORTANT
The removed protective plate and screw are required when the network
board is removed. Keep them where they will not get lost.
4 Insert the network board into the expansion slot.
Hold the metal panel portions of the network board and insert the board while
aligning it with the guide rails inside the expansion slot.
IMPORTANT
• Do not touch the network board parts, printed wire, or connectors with
your hands.
• Insert the printer connector of the network board securely into the
connector inside the expansion slot.
5 Secure the top and bottom portions of the network board
with the two screws supplied with the network board.
6 If you are using NB-C1, attach the ferrite core to the LAN
cable as shown in the figure.
Attach the ferrite core at 5 cm or less from the end of the connector which is
connected to the printer.
5 cm or less