lv5210_series_exp_cmd

EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210
8.4 IMAGE Command
8.4.1 CF_BRIGHT Command
COMMAND “CF_BRIGHT_%1” [CR]
%1
“000-063”------ Directly select the Bright Setting Value
“UP”---------------- Bright setting value +1
“DN”---------------- Bright setting value -1
Details
Set the User control Bright Value
The value set by the command will not be saved to the projector. Therefore,
when ALL OFF the projector, the value will return to the original setting.
(For STANDBYMODE, this value stays.) Only valid when it is in the usual
Power ON State.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.2 CF_CONTCOMMAND
COMMAND “CF_CONT_%1” [CR]
%1
“000-063”------ Directly select for conntrast setting value
“UP”---------------- Contrast setting value
“DN”---------------- Contrast setting value-1
Details
Set the user Control contrast value.
The value set by this command will not be saved to the projector. Therefore,
when ALL OFF the projector, the value will return to the original setting
(For STANDBYMODE, this value stays.) Only valid when it is in the usual
Power ON status.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.3 CF_COLORCOMMAND
COMMAND “CF_COLOR_%1” [CR]
%1
“000-063”------ Directly Color setting value
“UP”---------------- Color setting value+1
“DN”---------------- Color setting value-1
Details
Set the user Control Color value.
The value set by this command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (For STANDBYMODE, this value stays.) Only valid when it is in
the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
Page 15