lv5210_series_exp_cmd

EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210
8.5.2 CF_TDOTS COMMAND
COMMAND “CF_TDOTS_%1” [CR]
%1
“nnnn-9999”-- Directly set Total Dots value
“nnnn” is minimum value.
This is current Display Dots value＋Horizontal position value
“UP”---------------- Total Dots setting value ＋1
“DN”---------------- Total Dots setting value-1
Details
Set Total Dots of PC signal.（Only valid when it is in the usual Power ON
status.）
The value set by this Command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (Standby MODE stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ----Input-VIDEO
8.5.3 CF_CLAMP COMMAND
COMMAND “CF_CLAMP_%1” [CR]
%1
“0000-0127”---- Directly set Clamp setting value
“UP”------------------ Clamp setting value ＋1
“DN”------------------ Clamp Setting value -1
Details
Set Clamp of PC signal.（Only valid when it is in the usual Power ON status.)
The value set by this Command will not be saved to the projector..
Therefore, when ALL OFF the projector, the value will return to the
original setting.
（stay in STANDBYMODE.）
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ----Input-VIDEO
8.5.4 CF_H-POS COMMAND
COMMAND “CF_H-POS_%1” [CR]
%1
“0000-nnnn”-- Directly set Horizontal Position
“nnnn” means maximum value.
This result of current Total dots value-Display dots.
“UP”---------------- Horizontal Position value ＋1
“DN”---------------- Horizontal Position value-1
Details
Set horizontal position of PC signal.（Only valid when it is in the usual Power
ON status.）
This value set by this Command will not be save do the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (stays in STANDBYMODE)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ----Input-VIDEO
Page 19