lv5210_series_exp_cmd

EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210
8.6.2 CF_AVDLINECOMMAND
COMMAND “CF_AVDLINE_%1” [CR]
%1
“UP”............Current Setting+1
“DN”............Current Setting-1
Details
Set AV service MODE vertical resolution value.
(Only valid when it is in the usual Power ON status.)
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ----Input-VIDEO
8.6.3 CF_AVHPOS COMMAND
COMMAND “CF_AVHPOS_%1” [CR]
%1
“UP”............Current Setting+1
“DN”............Current Setting-1
Details
Set AV service MODE horizontal position value.
(Only valid when it is in the usual Power ON status.)
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ----Input S-VIDEO
8.6.4 CF_AVVPOS COMMAND
COMMAND “CF_AVVPOS_%1” [CR]
%1
“UP”............Current Setting+1
“DN”............Current Setting-1
Details
Set AV service MODE vertical position value.
(Only valid when it is in the usual Power ON status.)
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ----Input-VIDEO
8.6.5 CF_AVSERV COMMAND
COMMAND “CF_AVSERV_%1” [CR]
%1 “RST”
Details
Set AV horizontal/vertical resolution that is set in such as “CF_AＶ
DDOTS”/”CF_AＶＤＬＩＮＥ” to default setting value.
(Only valid when it is in the usual Power ON status.)
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns “101” [CR].
Page 22