Measurement Guide
A - SET A SOLID SURFACE PRIOR TO ASSEMBLY
Heavy snow load expected
Concrete / tiled floor & wall
The wall mounting prole (top back) can be adjusted
from 260 to 305 cm (102.4" to 120") measuring from
the ground to t your space.
Decide what height and distance from
the wall you would like to mount your
patio cover. This will determine the
roof angle. Please note that while the
product appearance may change slightly
as a result of that angle, the snow load
weight does not change.
The poles can be adjusted from 0 to 54 cm (0 to 21.3")
from the side edges. Adjust poles after assembly and
before anchoring.
Poles distance from the wall can be adjusted from 226
to 286 cm (89" to 112.5") as illustrated in the Diagram.
In case of expected heavy snow load, install all supplied poles.
In case of expected light or no snow load, 1 pole at the meeting point of two
extensions is sufcient (as shown as on page 2: AVAILABLE MODELS)
Wooden surface (floor or wall) Concrete / tiled floor & wall Wooden surface (floor or wall)
The screws and masonry
anchors supplied with the kit
are suitable for concrete / tiled
floor & wall xing only.
Please consult with an expert
regarding which fasteners
are suitable for other surfaces
types (not supplied).
Light or no snow load expected
C - FIT YOUR PATIO COVER DIMENSIONS TO THE SITE D - CUSTOM THE NUMBER OF POLES REQUIRED
B - USE THE RIGHT SCREWS ON YOUR SURFACE
EN
IMPORTANT
We recommend checking for restrictions or covenants for building this product
in your area. In addition we advise to check if you need to submit any forms or if
any permit is required prior to building the product.
SITE PREPARATION & FOUNDATION
6 cm / 2.4”
kg
lbs
A
B
C
B
kg
lbs
A
Wall mounting height
B
Pole side positioning
C
Pole to wall depth
EN FERIA PATIO COVERS - INFORMATION