User Guide

Durch Kombination einer Reihen- und einer Parallelschal-
tung des InCeiling Systems verändert sich die Impedanz
nicht.
Combined series/parallel circuitry of the InCeiling system
does not alter the impedance.
Anschlussmöglichkeiten / Wiring Possibilities
Die minimale Lastimpedanz des Verstärkers sollte zwischen
4-8 Ohm liegen.
The minimum load impedance of the amplifier should be
between 4 and 8 ohms.
Bei Parallelschaltung des InCeiling Systems halbiert sich die
Impedanz von 8 Ohm auf 4 Ohm. Die minimale Last-
impedanz des Verstärkers muß bei 4 Ohm liegen.
The minimum load impedance of the amplifier must be 4
ohms. When the InCeiling systems are connected in paral-
lel, impedance is reduced by half – from 8 ohms to 4 ohms.
Achten Sie darauf, die Systeme nicht zu überlasten. Am sichersten ist
dies gewährleistet, wenn Ausgangsleistung des Verstärkers und Belast-
barkeit der Lautsprecher einander entsprechen. Aber auch Verstärker mit
größerer Leistung stellen dann keine Gefahr dar, wenn Sie darauf ach-
ten, den Lautstärkeregler nicht höher als zuträglich aufzudrehen. Eine
Überlastung der Lautsprecher macht sich durch unüberhörbare Verzer-
rungen bemerkbar.
Be careful not to overload the system. The most reliable way to
assure this is to see that the output power of the amplifier and the
power handling rating of the speakers conform with each other.
However, even amplifiers with greater power are no danger if you
are sure not to turn up the volume higher than tolerable. Speaker
overload quickly makes itself audible as unmistakable distortion.
Belastbarkeit / Power Handling
As indicated by the Technical Data, the impedance (nominal
resistance) of these systems is 8 ohms. Virtually all amplifiers on
the market today can safely be connected with these speakers. If
you wish to drive two speakers from one amplifier channel, you
can connect them in parallel. However, make sure that the
impedance of this configuration is not less than the lower
impedance limit of your amplifier.
Wie die technischen Daten ausweisen, liegt die Impedanz (der
Scheinwiderstand) dieser Systeme bei 8 Ohm. Nahezu alle heute
angebotenen Verstärker lassen sich problemlos mit diesen Laut-
sprechern verbinden. Möchten Sie zwei Lautsprecher an einen
Verstärkerkanal anschließen, können Sie diese parallel schalten.
Versichern Sie sich aber, dass die Impedanz dieser Konfiguration
nicht unter die untere Impedanz-Grenze ihres Verstärkers fällt.
Impedanz / Impedance
8 Ohm
8 Ohm
4/8 Ohm
8 Ohm
8 Ohm8 Ohm 8 Ohm
4 Ohm
8 Ohm 8 Ohm8 Ohm 8 Ohm
8 Ohm 8 Ohm8 Ohm 8 Ohm
16 Ohm 16 Ohm
16 Ohm 16 Ohm
4/8 Ohm
InCeiling.pmd 20.12.2003, 12:163