Instruction Manual

EN - 1

Bluetooth Speaker

Article : CNA-BTSP01x Quick Guide V1.0

Package Contents

‧CNA-BTSP01x Bluetooth speaker

‧Quick guide ‧3.5mm audio cable

‧Rechargeable battery ‧Micro USB charging cable

Hardware Overview

1. Previous; 2. LED indicator; 3. Next; 4. Volume down; 5. Mic; 6. Play/Pause or

incoming call; 7. Volume up; 8. Battery charging LED indicator; 9. USB DC in

10. ON/OFF Switch; 11. Battery cover; 12. AUX input

LED indicator

1. There is an LED light on the top of Bluetooth speaker. The LED indicates the status

of speaker :

‧LED Off – Power Off ‧Blue – Power On

‧Flashing blue – Pairing mode ‧Green – AUX input

2. There is an LED light on the back of Bluetooth speaker. The LED indicates the

status of battery charging :

‧RED –Battery is recharging ‧Green –Battery is full charged

Controlling

‧ Increase volume

‧ Decrease volume

‧ Play / Pause / incoming call answer

‧ Next

‧ Previous

PAGE 1
Bluetooth Speaker Article : CNA-BTSP01x Quick Guide V1.0 Package Contents ‧CNA-BTSP01x Bluetooth speaker ‧Quick guide ‧Rechargeable battery ‧3.5mm audio cable ‧Micro USB charging cable Hardware Overview 1. Previous; 2. LED indicator; 3. Next; 4. Volume down; 5. Mic; 6. Play/Pause or incoming call; 7. Volume up; 8. Battery charging LED indicator; 9. USB DC in 10. ON/OFF Switch; 11. Battery cover; 12. AUX input LED indicator 1. There is an LED light on the top of Bluetooth speaker.
PAGE 2
Quick Start 1. Insert battery into the bottom side of the Bluetooth speaker. 2. Turn the power switch to ‘ON’ position and you will hear a beep sound in 3 seconds. 3. After turning the speaker on, the LED indicator should flash every 0.5 seconds, it’s in “pairing mode.” 4. The speaker is now ready to connect to your Bluetooth enabled device. Please refer to your Bluetooth enabled device’s instruction manual for pairing instructions if you are unsure how to do this. Pairing with Bluetooth enabled devices 1.