User's Manual

3-Butt

on Remote MODEL: GG-318 Preliminary Copy

INTR

ODUCTION

hank you for your purchase of Skylink® remote transmitter,

Model GG-318.

The following items are included in this package:

- One of GG-318 Remote

- Lithium Battery CR-2032 (Installed)

- Mounting accessories

ollow one or more instructions below to program transmitter GG-318 to the Skylink® receiver

or Skylink® garage door opener you want to control.

2. PROGRAMMING

2a. PROGRAMMING A REMOTE TRANSMITTER TO THE SKYLINK® GARAGE DOOR

OPENER

TOMS

ERIES

1. Connect the opener to an approved power source.

The dot in the LED display stays on.

. Press the [Set] button for one second, and release the

. Within 30 seconds, press any button on the remote

that you would like to program to the opener.

Note:

[

] = B

utton 1, [

] =

Button 2, [

] = Butt

on 3

. Once the button on the remote is programmed. The

LED segment will off and emits one beep indicating

the programming successfully

Button

PAGE 1
3-Button Remote MODEL: GG-318 Preliminary Copy 1. INTRODUCTION Thank you for your purchase of Skylink® remote transmitter, Model GG-318. The following items are included in this package: - One of GG-318 Remote - Lithium Battery CR-2032 (Installed) - Mounting accessories Follow one or more instructions below to program transmitter GG-318 to the Skylink® receiver or Skylink® garage door opener you want to control. 2. PROGRAMMING 2a.
PAGE 2
b. PROGRAMMING A REMOTE TRANSMITTER TO THE SKYLINK® RECEIVER GB-318 Refer to the receiver Smart ButtonTM GBup the unit. 1. Press the learn button on the side of the Smart ButtonTM GB-318. 2. Once the learn button is pressed, the LED will flash quickly. Release the learn button. 3. Within 30 seconds, press any one of the 3 buttons on the transmitter that you want to program to the receiver. 4. Once the remote control is programmed, the LED will flash slowly, in the same way as it flashes in standby mode.
PAGE 3
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux CNR exempts de licence d'Industrie Canada.