Service manual

GV 30…, GV 50… Allgemeiner Teil / General Section
GRUNDIG Service 1 - 33
58
SPECIAL SETTINGS
____________________________________________________________________
9 Fine tune the station if necessary by pressing »
C
« or »
D
« to select » FINE
TUNING« and then pressing »
F
« or »
E
«.
10 Select the »SKIP« line using »
C
« or »
D
« and then press »
E
« to select
»OFF«.
11 Press » OK « to save the setting for that station.
– The cursor jumps to the »PRESET« line and the next channel position is
displayed.
Note:
To tune to more stations repeat steps 4 to 11.
12 Press » i INFO« to finish the setting.
PRESET ----- 21
CHANNEL C 49
SOURCE C/S
FINE TUNING
< >
■
➔
SKIP OFF
DECODER OFF
ɶʺ
:SELECT <> :CHANGE
OK :ENTER INFO :EXIT
■
➔
PRESET ----- 22
CHANNEL C 46
SOURCE C/S
FINE TUNING
< >
SKIP OFF
DECODER OFF
0-9 :DATA
ɶʺ
:SELECT <> :CHANGE
OK :ENTER INFO :EXIT
SPECIAL SETTINGS
____________________________________________________________________
ENGLISH
59
Switching the station on the video recorder on and off
If there are a lot of stations which your video recorder can receive in the UHF
band between channels 21 and 69, it may lead to picture impairment when
using the recorder.
If the station on the video recorder is switched off, the video recorder and the
television must be connected with a EURO-AV (Scart) cable (see ”Connection
and preparation” on Page 11).
Switching off the station on the video recorder
1 Press »
Ǽ
« to switch the video recorder to standby, then press and hold down
»INFO«.
2 Press »CLEAR« to switch off the station on the video recorder.
– »
OFF RF « appears in the video recorder display.
3 Conclude the setting by pressing » OK «.
Switching on the station on the video recorder
1 Press »
Ǽ
« to switch the video recorder to standby, then press and hold down
»INFO«.
2 To switch on the station on the video recorder, use » 0 ... 9 « to enter a two-
digit channel number.
– The display on the video recorder reads something like »
CH 27 RF «.
3 Conclude the setting by pressing » OK «.