- Excalibur Indoor Fireplace User Manual

Excalibur

P90 Zero Clearance Direct Vent Gas Fireplace 11

VENTING

FPI Direct Vent System (Flex) Horizontal Terminations Only

These venting systems, in combination with the P90 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by

Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in the "Exterior Vent

Termination Locations" section.

FPI Direct Vent (Flex) System Termination

Kit (Part # 946-515) includes all the parts

needed to install the P90 with a maximum

run of 4 feet.

1) 6-7/8" dia. ﬂ exible liner (4 ft. length)

2) 4" dia. ﬂ exible liner (4 ft. length)

3) spring spacers (4)

4) thimble (2)

5) AstroCap termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point, Stainless

Steel (4)

If a longer run is needed, the FPI Direct Vent

system (Flex) kit is 946-516 which includes

all the parts needed to install the P90 with a

maximum 10' run.

1) 6-7/8" dia. ﬂ exible liner (10 ft. length)

2) 4" dia. ﬂ exible liner (10 ft. length)

3) spring spacers (7)

4) thimble (2)

5) AstroCap termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point, Stainless Steel

(4)

Notes:

1) Liner sections should be

continuous without any joints or

seams.

2) Only Flex pipe purchased from FPI may

be used for Flex installations.

3) Horizontal vent must be supported every

3 feet.

INSTALLATION