- Excalibur Indoor Fireplace User Manual

Excalibur
®
P90 Zero Clearance Direct Vent Gas Fireplace
30
Place embers in these 3 locations
on the burner tray.
Log indentation
Photo shows rear grate tab.
Log 02-51 was removed to show
the positioning of Log 02-52.
Rear
Grate
Tab
02-52
02-75
02-51
02-54
02-52
02-54
Rear Bracket
02-55
02-75
02-51
02-53
7) Place the bottom left front edge of Log
02-55 against the rear bracket on the burner
tray and rest the log on the cutout on Log
02-53.
Cutouts
8) Place Log 02-52 between Logs 02-51 and
02-75 and on the indentation on Log 02-54.
The bottom right end sits behind the rear
grate tab.
Front Brackets
Notch
02-50
02-50
02-55
02-75
02-53
02-51
02-54
02-55
02-53
02-50
02-55
02-53
9) Sit Log 02-50 on the front left side of the
burner. Push the back of the log against
the 2 front brackets with the notch on the
bottom of the log fi tting into the fi rst grate
tab.
10) Place the embers on the front of the burner
tray in the places shown on the photos
below.
11) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end of
burner to the other). If there is any fl ame
hesitation, check that area for any blockage
of the burner ports.
12) Install fl ush glass and bay glass (if used) as
per instructions in this manual.
Do not block the burner holes in this
area adjacent to the Log 02-54
02-51
02-54
INSTALLATION