Manual

2132/2116 Controller
6 MC02 – .08
3.1 Setting the Timer Mode
Scroll to tm.OP; use  or  to view and alter the mode. The mode shows as OPt.1 to OPt.5.
It is not possible to alter the mode while the timer is running; if the mode cannot be altered, scroll
to the StAt parameter and set its value to OFF.
3.2 Setting the Time Period
Method 1
Scroll to tmr (time remaining). Use  or  to view the remaining time; the units are always in
minutes. Use  and  to set or alter the time. Setting tmr automatically activates the timer; the
m-A parameter changes to Auto and the StAt parameter changes to run.
Note that the tmr display shows 0 (zero) during the last minute of timing, and also shows 0 when
the time has expired. The timer light indicates whether timing is still in progress.
Method 2
Scroll to dwEl, and use and  to set the timing duration. The advantage of method 2 is that
dwEl need only be set once if repeated use of the same time period is required.
Scroll to StAt, and use  or  to set the parameter value to run. This copies the dwell time into
tmr and activates the timer as in method 1.
3.3 Running with the Timer
Once the timer is activated by method 1 or 2 above, the control sequence depends on the timer
mode, as previously given in the table. Fig 3 gives another representation of the timer action.