User guide

5.4 BUSY SIGNAL
When attempting to establish an Intercom call with another device
that is already busy, a “busy” signal will be heard. The scala rider is
busy while on a phone call, intercom call with Channels “A” and “B”,
“1+8” intercom call or Click-to-Link call.
5.5 RECEIVING INTERCOM CALLS
If a paired unit tries calling you via Intercom, the call will begin
almost instantly.
5.6 GROUP SIGNAL
Send an instant message to all paired scala rider G9 / G9x and
cardo SHO-1 units within a range of up to 350 m. The
recipients will hear a “Signal!” voice announcement. To reach a
maximum number of riders, the message is automatically
forwarded to all paired units within the recipient’s range. In this
manner the total range is extended to up to 1 km.
Send a Group Signal
Double tap
The transfer of wireless signals is subject to multiple external factors.
Therefore, users may use but should not rely on the Group Signal for
emergency purposes.
6. PAIRING AND USING A MOBILE PHONE,
GPS OR MP3 PLAYER
To use a Bluetooth device with your scala rider you must rst pair
them. Once paired, they will automatically recognize each other
whenever they are within range (10m / 33ft).
Your unit has two Bluetooth channels for connection to mobile
phones, GPS devices and music players with A2DP.
6.1 PAIRING BLUETOOTH CHANNELS 1 AND 2
1. Make sure Bluetooth is enabled on your phone/GPS/MP3 player.
2. Check the unit is in Standby (single BLUE ash every 3 seconds).
3. To pair Bluetooth Channel 1 – press for at least 5 seconds
until the RED and BLUE LEDs begin rapidly alternating.
To pair Bluetooth Channel 2 – press for at least 5 seconds
until the RED and BLUE LEDs begin rapidly alternating.
To pair a GPS, when LEDs begin rapidly alternating, tap .
4. Search for Bluetooth devices on your phone/GPS/MP3 player by
following the device’s instructions.
5. After a few seconds the device will list “scala rider G9x”. Select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The device will conrm that pairing has succeeded and the LED
will begin ashing Blue, once every 3 seconds.
8. If pairing is not completed within 2 minutes, the unit will return
to Standby mode.
IMPORTANT!
• If you have paired 2 dierent mobile phones directly to your
scala rider G9x, you will need to set one as default for making calls.
• If your GPS supports it, you can pair the second mobile phone
directly to the GPS and then pair the GPS to your scala rider G9x,
and so connect both mobile phones and the GPS to your
scala rider G9x.
12 | scala rider
®
G9x / G9x PowerSet