Owner`s manual

MANUAL PATIO AWNING

SING THE

TANDARD

PTIONS

THESE STANDARD OPTIONS ARE PROVIDED WITH THE SPIRITFX UTILITY ROLL BAR.

TIE-DOWNS

1. Remove the plastic containing tube from the utility slot roll then remove the

tie down strap and spring from the tube.

2. Place the tube back into the slot for storage. Push tube straight in. (This will cause

the plastic to collapse slightly then “pop” into the slot.)

3. Slide the strap to the end of the roller tube and next to the end cap.

4. Wrap the strap over the top of the tube between the end cap and fabric.

5. Pull the strap out away from the awning.

6. Attach a corkscrew anchor to the end of the shock spring.

7. Pull the strap tight to determine the location of the anchor.

8. Install the anchor into the ground. The head of the anchor should be tilted

away from the awning.

9. After screwing the anchor into the ground, cinch the strap tight.

10. Reverse the procedure for storage.

THIN-LITE

The Thin-Lite is stored in the utility slot of the Spirit FX roll bar.

Foam Plug

Coiled

Power Cord

ThinLite004a

Foam Plug

12VDC Power

Receptacle

Plug From Light

Plug Storage

Hole

DETAIL A DETAIL B

Light

1. Extend the awning out completely.

2. Remove the power cord from the utility slot.

3. Slide the light to the desired location along the roll bar.

4. Use the foam plugs to hold the light in position.

5. (Detail A) Connect the cord to the receptacle.

NOTE: During times when the light is not needed but the awning remains

extended (such as during the day), the cord can be unplugged to shut off the

light and the plug stored in the storage hole of the receptacle bracket (Detail B).

6. Before rolling the awning up, coil the cord into the utility slot. Push the cord plug

into the foam plug then push the plug toward the light to hold the cord in place.

CAUTION

TO PREVENT DAMAGE TO THE CANOPY, THE CORD MUST BE STORED IN THE SLOT

BEFORE THE AWNING IS RETRACTED