User Manual

3
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
 1 4 CHANNEL RADIO WITH 4 MICRO SER-
VOS. (WE USED 4 CHANNEL FUTABA
RADIO WITH S3108 SERVOS AND GREAT
PLANES ELECTRIFLY RECEIVER W/O
SPEED CONTROL)
 1 6” SERVO “Y” HARNESS
 2 6” SERVO EXTENSIONS
 1 ELECTRONIC SPEED CONTROL (WE
USED A CASTLE CREATIONS PHOENIX
25 BRUSHLESS SPEED CONTROL)
 1 3 CELL LI-PO BATTERY (GREAT PLANES
ELECTRIFLY 1500)
 1 ULTRAFLY BRUSHLESS MOTOR A/30/29
WITH 3.89 GEAR RATIO
 1 GREAT PLANES ELECTRIFLY PROP
ADAPTER 3MM APC LONG
 1 APC PROPELLER 9 X4.7 SLO FLYER
 1 CA ACCELERATOR
 1 1 OZ. BOTTLE CA MEDIUM GLUE
 1 1/2 OZ. BOTTLE CA THIN GLUE
 1 5 MINUET EPOXY
 1 1/4” FOAM RUBBER
 1 #2 X 1/4” SHEET METAL SCREW FOR
MOTOR(MIGHT BE REQUIRED FOR SOME
MOTOR INSTALLATIONS)
TOOLS AND SUPPLIES FOR ASSEMBLY.
 MODELING OR UTILITY KNIFE
 WORK SURFACE (24" X48")
 SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
 MASKING TAPE
 NEEDLE NOSE PLIERS
 24” RULER
 FLEXIBLE STRAIGHT-EDGE
 30-60-90° x 6" TRIANGLE
 SOFT PENCIL
 A FEW STRAIGHT OR "T" PINS
 WIRE CUTTER (DYKES)
 OPTIONAL HEAT GUN/COVERING IRON
 ACID BRUSH
 5 FT. LENGTH OF STRING
Caution:
Before starting, care-
fully go over all high
stress areas (Wing
bolt mounting blocks,
Firewall,etc.) with an
epoxy or wood glue to
confirm all areas are
well glued.