User Manual

7
Stabilizer
1.  Collect the following parts:
(1) Fuselage
(1) Stabilizer & Elevator
(1) wing
(1) 4-40 x 1/2” Socket Head Bolt
(1) Wooden Washer covered in red
2.  Locate the hole in the center of the wing for
the wing bolt. Remove the covering over the
hole.
 Mount the wing to the fuselage using the bolt
and wooden washer.
 Make an out line of where the wooden wash-
er rest on the wing.
 Remove the covering on the wing where the
wooden washer will rest.
 Glue the wooden washer to the wing.
3.  Find the center of the stabilizer, by measuring
the length of the trailing edge where the ele-
vator hinge line is located.
 Stand the stabilizer up on its edge and using a
right triangle draw a center line up from the
trailing edge to the leading edge.
 Find the center of the fuselage in front of
where the stabilizer sits.
 Place the stabilizer on the fuselage using the
marks you just made.
“X”
“X”
4.  Measure from the end of the wing to the tip of
the stab. This measurement should be the
same for both sides.
 Mark the stabilizer where it rest on the fuse-
lage
 Remove the covering where the stab will be
glued to the fuselage.
 Look down the length of the fuselage and
check that the stabilizer is parallel to the wing.
If it is not then shim the low side till they are
parallel.
 When satisfied then glue the stabilizer in place
using 5 minuet epoxy. Make sure the stabiliz-
er remains both perpendicular and parallel to
the wing and fuselage while the epoxy dries.
2.  Remove the balsa wood plug at the rear of the
fuselage where the stabilizer mounts.
Elevator Installation
1.  Collect the following parts:
(1) Fuselage With Stabilizer
(2) Elevator
(4) Mini CA Hinges
(1) Nylon Control Horn
(1) Long Pushrod Wire
2.  Locate the slot in one side of the elevators
near the center.
 Remove the covering over the slot.
Bottom of Elevator