User Manual

8
3.  Insert the mini hinges into the slots in the ele-
vator.
 Take the long wire pushrod and insert the “Z”
bend end into the outer hole of the control
horn.
 Insert the wire into the hole in the side of the
fuselage.
 Push the elevator forward and insert the
hinges into the stabilizer. (use pins to keep the
hinges centered)
 Glue the hinges in place same as you did the
aileron.
Fin & Rudder Installation
1.  Collect the following parts:
(1) Fuselage With Stabilizer
(2) Fin & Rudder
(2) Mini CA Hinges
(1) Nylon Control Horn
(1) Long Pushrod Wire
 Glue the Nylon control horn into the slot mak-
ing sure that the elevator is placed on the
work bench as shown in the previous photo.
3.  Insert the fin into the fuselage slot.
 Mark where the fuselage meets the fin.
 Remove the fin from the fuselage.
 Carefully cut the covering off the fin where the
fin will be glued to the fuselage.
 Remove the rudder from the fin and glue the
fin to the fuselage making sure to keep the fin
perpendicular to the stabilizer.
2.  Locate the slot in the rudder near the bottom.
 Remove the covering over the slot.
 Glue the Nylon control horn into the slot mak-
ing sure that the rudder is placed on the work
bench as shown above.
3.  Insert the mini hinges into the slots in the rud-
der.
 Take the long wire pushrod and insert the “Z”
bend end into the outer of the control horn.
 Insert the wire into the hole in the top of the
fuselage next to the fin.
 Push the rudder forward and insert the hinges
into the fin. (use pins to keep the hinges cen-
tered)
 Glue the hinges in place.