User Manual

9
Landing Gear
1.  Collect the following parts:
(1) wing
(2) Main Landing Gear Wire
(4) 2mm x 6 Sheet Metal Screw
2.  Remove any covering over the landing gear
slot.
 Insert the short end of the main landing gear
wire into the hole.
 Locate the two holes next to the landing gear
slot.
 Screw the landing gear into place using two
2mm x 6 Sheet Metal Screws.
Fuselage
Wheel Pants
1.  Collect the following parts:
(1) wing
(2) Wheel Pants
(2) Wheel Collars with set screws
(4) 2mm x 3mm Sheet Metal Screw
(2) Landing gear strap
(2) Wheels
Landing gear Wire
Wheel Pant
Wheel
Wheel Collar
Landing Gear Strap
2mm x 3mm Sheet Metal Screw
2.  Place the wire though the back side of the
wheel pants.
 Insert the wheel into the wheel pant.
 Push the landing gear wire through the wheel
and out the other side of the wheel pant.
 Insert the wheel collar on the end of the land-
ing gear wire.
 While slightly squeezing the wheel pant tight-
en the wheel collar onto the landing gear wire.
3.  Place the landing gear strap onto the landing
gear wire so that the slot in the strap fits over
the wire.
 Screw the strap to the wheel pant using the
2mm x 3 sheet metal screws.
 Repeat steps 2 & 3 for the other wheel pant.