Adit 3104 User Manual

4-8 Adit 3104 - Release 1.6

Configuration

Basic Configuration

The following configuration is divided into logical sections, where each section configures an additional

function. The first must be configured before the second and so forth, however, you may stop at any

section and not add the following feature.

NOTE: The order in which commands are entered can affect the successful provisioning of

the Adit 3104.

 Setup Adit 3104 for access via Web-Browser

 Restore Factory Defaults

 Modify Default Admin User

 Configure Ethernet WAN Interface

 Configure Serial1 as WAN

 Configure the Adit 3104 as a SIP Line Gateway

Setup Adit 3104 for access via Web-Browser

The following steps will configure the Adit 3104 to allow access to the Web Browser for configuration,

through one of the 4 10/100Base-T LAN connections.

Note: For LAN access, no additional configuration is required to access the Adit 3104 using the web

browser.

To configure the WAN access:

1. Connect to the CLI via the DB-9 RS-232. See Setting up a CLI Connection on page 4-5.

2. Enable the remote admin WAN access with the following command sequence:

Command Description

Username: admin

Password: ********

Log into the system (username and password).

Adit 3104> enable Enter the Privileged mode.

Password: ********

Enter password for the Privileged mode.

#configure terminal

Enter the Configuration mode.

(config)# remote-admin web

primary-port enable

Enable remote web admin.