User manual

8 Adit 600 - Release 10.1.1
Quick Start
Compliant Installation
NOTE: It is important that the Signal Cables are secured separately from the
Power Cables, for proper equipment operation.
Ferrite Beads (US)
NOTE: E1 is not supported in this release of the Adit 600 Controller. It will be
supported in a future release.
To be compliant with Part 15A of the FCC and for NEBS compliant facilities, the
following ferrite beads are required for the chassis and service cards listed below.
Ferrite beads for Adit 600 chassis:
Service card cables requiring ferrite beads:
*The CMG-01 and CMG-02 Router cards do not require a ferrite bead.
For additional information on ferrite beads and their installation on the Adit 600, please
contact Force10 Networks Customer Support at 1-866-887-4638 (US) or 1-707-665-
4355 (International/Direct).
Ferrite Part Number Intended For
3 small P/N 010-0095 (2) One on each T1 or E1 cable
(1) Ethernet (10Base-T) cable
1 large P/N 010-0051 (1) Alarm cable, which requires a loop
through the bead (see drawing)
Card Ferrite Part Number Intended For
ISDN BRI 1 large P/N 010-0051 (1) 25-pair Telco cable (ISDN BRI
card in slot 1-3 top telco, 4-6 bottom)
Quad DS1/E1
Quad T1
Quad E1
1 large P/N 010-0051 Cables from front of card
(1 bead can hold 1-4 cables) or,
(1) One on 25-pair Telco cable
IP Router 1 small P/N 010-0095 Ethernet Cable (from front of card)
CMG Router* 1 small P/N 010-0095 Ethernet Cable (from front of card)