User manual
Adit 600 - Release 10.1.1 9
Quick Start
Compliant Installation
Ferrite Beads (Europe, Australia and Canada)
NOTE: E1 is not supported in this release of the Adit 600 Controller. It will be
supported in a future release.
To be compliant with EN55022 and CISPR22 Class A emissions, the following beads
are required for the chassis and components listed below. Also, shielded cables are
required for the V.35/54 service card and must be ordered separately.
Power Cord
-48 VDC
Battery Power
Alarm Wiring
Signal Cables
Power Cables
Grounding Cable
Ferrite Bead
with cable loop
RS-232 craft port
25-pair telco connector
25-pair telco connector
10Base-T Ethernet
T1/E1 connectors
Ferrite Beads
areinred
Ferrite Beads
with cable loop