User manual

12 Adit 600 - Release 10.1.1
Quick Start
Interface Connectors
Chassis Ground Connector
WARNING! THIS EQUIPMENT IS REQUIRED TO HAVE A PERMANENT GROUND
CONNECTION. IF CONNECTED TO EXPOSED OUTDOOR COMMUNICATION
CONDUCTORS, A #6 AWG COPPER WIRE MUST BE PERMANENTLY CONNECTED
FROM AN APPROVED GROUNDING ELECTRODE TO THE CHASSIS GROUND LUG.
O
THERWISE, A #14 AWG COPPER WIRE MAY BE UTILIZED. INSTALL THE GROUNDING
CONDUCTOR IN ACCORDANCE WITH NATIONAL OR LOCAL REGULATIONS.
1. Route wire (#6 or #8 AWG copper) from building ground to lug on Adit 600.
2. Strip insulation off wire end, if necessary.
3. Loosen compression screw until opening is large enough to accept ground
wire.
4. Insert ground wire into lug barrel, beneath compression plate and tighten
compression screw.
5. Attach ground lug to chassis
Ground Terminals
Ground Lug
Compression
Screw
Lug Barrel