User manual

Adit 600 - Release 10.1.1 23

Quick Start

Management Options

Options for managing the Adit 600 are as follows:

 Local using CLI, Telnet, SNMP, or DIP Switches (Controller and voice cards)

 Remotely over an in-band DS0 or through the Access Navigator over the FDL

or an in-band DS0

This Quick Start Guide focuses on the CLI and DIP switches. If you need further

information on other management options, please refer to the Adit 600 User Manual.

Command Line Interface (CLI)

You can access the CLI using either of the following methods:

 Telnet via Ethernet (10Base-T)

 RS-232 connected to the DB-9 port

Setting up a CLI Connection

 If connecting via the Ethernet 10Base-T connection, use a Telnet TCP/IP

program to access the CLI. This requires the IP address of the Controller.

Controllers are shipped with the IP address set to 10.0.0.10. If this address has

been changed and is not known, use HyperTerm to access the Controller and

use the CLI command show ip. If an IP address needs to be set, use the CLI

command set ethernet ip address.

 If connecting via RS-232, the port settings should be set to:

Bits per second: 9600 Data bits: 8

Parity: None Stop bits: 1

Flow control: None

 Set your Terminal Emulation to VT100.

 By default, the Adit 600 is set for local configuration (using DIP switches). Use

the set local off command to enable the use of CLI commands.