User manual

Adit 600 - Release 10.1.1 31
Quick Start
Configuration
4-Wire E&M Setup
For this example the 4 E&M ports will be connected to the first 4 DS0s on T1-1 (a:1).
This can be changed to match the customer's desired DS0 connections.
For Transmission Only mode, the DS0s on the DS1 should be set to data, as well as the
E&M card channels.
Command Description
For Normal or Tandem E&M:
set a:1:1-4 type voice
Set DS0s to voice.
set connect a:1:1-4 1:1-4
Connect DS0s to the 4 ports of the 4-
Wire E&M card.
show connect a: 1
Verify cross connects.
set a:1:1-4 signal emi
Set DS0 signal type to EMI.
set 1:1-4 signal emi
Set 4-Wire E&M ports signal type to
EMI.
show connect a:1
Verify cross connects.
For TO Mode:
set a:1:1-4 type data
Set DS0s to data.
set 1:1-4 type data
Set 4-Wire E&M port to data.
set connect a:1:1-4 1:1-4
Connect DS0s to the 4 ports of the 4-
Wire E&M card.
show connect a: 1
Verify cross connects.