User manual

Adit 600 - Release 10.1.1 33
Quick Start
Configuration
OCU-DP Card Setup
The following is a basic setup for the OCU-DP card.
ADPCM Card Setup
Command Description
set {ocudp-addr} baud
{2400|4800|9600|19200|38400|
56000*|64000}
Set the OCU-DP Baud rate.
Where ocudp-addr = {slot:port} of the
OCU-DP card to apply settings to.
set {ocudp-addr} up Set the OCU-DP port 1 up.
show {ocudp_card-addr} Show the OCU-DP card settings.
Where ocudp_card-addr = {slot} of the
OCU-DP card.
disconnect a Disconnects all connections to slot a
(controller)
set {ds0-addr} type data Sets a DS0 data signaling type
connect {ds0-addr}
{ocudp-addr}
Connects DS0 (in previous step) to OCU-DP
port (in previous step).
show connect
(ocudp_card-addr}
Displays connect information for OCU-DP
card.
Command Description
Connect T1 cable to port 1 of the ADPCM service card
set {adpcm_card-addr}
{none|map1|map2|map3}
Enable compressing by selecting Map type. Note:
none disables compression.
show (adpcm_card-addr} Displays the status of the card, and the mapping.
connect 2:1:1-12 2:4:1-12 Set ADPCM cross-connects. The example
connects all 24 channels of the ADPCM to the 12
channels of the T1 (now compressed) on port 4.
This example is with map2
show connect {2:1) Displays the connections made above.